Winton Machinery

Winton 1.25m Tractor Verge Flail Mower W-VF125

Name: Winton 1.25m Tractor Verge Flail Mower W-VF125
Brand: Winton Machinery

The W-VF125 is the narrower model in Winton's W-VF verge flail range. Same hydraulic offset and tilt geometry as the wider sibling, but a 1.25m head matched to 20–40 HP Cat 1 tractors and the tighter verges where a bigger machine would be too much. Reach beyond the wheelbase Two double-acting spools drive the right-hand hydraulic offset and the head tilt. The operator stays seated on the carriageway or track while the flail works the bank alongside. Tilt runs 90° up for the side of a low hedgerow and 50° down into a ditch or sloped verge. Cut quality on rough and managed grass Twenty-two hammer blades sit in a spiral pattern on the belt-driven rotor — three drive belts power the shaft. Heavier hammer flails and a heavier gearbox bite into overgrown weed; on regular passes over already-managed grass the same rotor leaves a finer finish. Height control on uneven ground An adjustable rear roller plus two height-adjustable skids set the cut between 3 and 8 cm and keep the blades off the high spots on a lumpy verge. 1.25m working width — sized for tighter verges and smaller compact tractors 20–40 HP tractor range, Cat 1 three-point linkage Right-hand hydraulic offset, run from 2 double-acting spools Cutting head tilts 90° up to 50° down from the same seat position 22 spirally-arranged hammer blades on a belt-driven rotor (3 drive belts) Adjustable rear roller and twin skids set a 3–8 cm cut height 264 kg, 138 × 68 × 57 cm — PTO and hydraulic drive . Department: Tractor Flail MowersShow more

from £2,888.00

1 offer

See all offers